現在，您可以操作設備以完成設定：


  1. 開啟已在 DEP 中註冊的所有設備

  2. 確保設備已連接到 Internet

  3. 如果設備是全新的，則將設備連接上網後，部署將自動開始

  4. 如果設備已啟動，並且位於主屏幕上，請點擊「設定」>「重置」>「刪除所有內容和設置」。按鍵「備份後刪除」或「立即刪除」

  5. 等待直到部署完成。請注意，這可能需要一些時間，如果您要設定大量的設備，並且需要將應用程序推送到設備上，則該過程將花費更長的時間。當然，您的上網頻寬也會影響設定的速度

  6. 驗證：您可以進入 ESP 管理控制台去檢查設備是否已添加到“設備管理”列表中。進入「設備」>「設備管理」

  7. 在設備上，點擊 ESP 圖示


  8. 如果彈出視窗關於需要位置顯示，請選擇「永遠允許」

  9. 如果彈出視窗關於收發通知事項，請選擇「永遠允許」

  10. 完成!!!


7. Activate Devices (iPad)

 


You are doing very well up this point.  Now you can touch your devices to finalize the setup


  1. Take out all the devices you have registered in DEP

  2. Make sure the devices are connected to the Internet

  3. If the devices are brand new, once the devices are connected to the Internet, the deployment starts automatically

  4. If the devices have been initiated and you are on the homescreen, tap Settings > Reset > Erase All Content and Settings.  Tap Back Up then Erase or Erase Now

  5. WAIT until the deployment completes. Please note that it may take some time, the process will take longer if you have a lot of devices to be deployed and apps to be pushed onto the devices. Certainly, the bandwidth of your internet connectivity is a major factor as well

  6. Verification: you can go to ESP Admin Console to check if the devices have been added into your Device Management list.  Go to Device > Device Management

  7. On your devices, tap ESP icon


  8. If prompt for Location Services, please choose Always Allow

  9. If prompt for Notification, please choose Always Allow

  10. COMPLETE!!!